Masimo Radical Signal Extraction Manuale dell'Operatore Scaricare il pdf (Pagina 11)

2-4 Rad-57 Signal Extraction CO-Pulse Oximeter Operator’s Manual

Rad-57 Signal Extraction CO-Pulse Oximeter Operator’s Manual 3-1

system description

X X X X X X

FOR PLACEMENT ONLY

2XXX

Masimo Corporation

Irvine, CA 92618

USA

Rad-57

Only

Masimo Corporation

Irvine, CA 92618

USA

Rad-57

Only

X X X X X X

FOR PLACEMENT ONLY

2XXX

X X X X X X

FOR PLACEMENT ONLY

2XXX

Rad-57 rear panel

CONTROL / INDICATOR

DESCRIPTION

Serial Number Label

One label located inside battery compartment, one on

outside of case

Agency Approvals Label

Battery Cover

Battery Cover Release

Press down and slide the battery cover off the bottom of

the oximeter

SYMBOLS

SYMBOL DESCRIPTION

Caution, consult accompanying documents

Type BF applied part complying with IEC 60601-1

WEEE Compliant

Introduction

Before the Rad-57 Pulse CO-Oximeter can be used in a clinical setting, it needs to be

inspected, properly setup and the batteries need to be installed.

Unpacking and inspection

Remove the instrument from the shipping carton and examine for signs of shipping

damage. Check all materials against the packing list. Save all packing materials, invoice

and bill of lading. These may be required to process a claim with the carrier.

If anything is missing or damaged, contact the Technical Service Department. The contact

address and phone numbers are listed in Section 9, Service and Repair.

Preparation for monitoring

The following sections of the manual describe the preparation, set-up and initial installation

of the Rad-57 Pulse CO-Oximeter.

POWER REQUIREMENTS

The Rad-57 is powered by 4 “AA” alkaline batteries. Do not use any other type of batteries

or power source to run the device. The battery compartment is accessed from the back of

the device. To install the batteries first remove the battery cover by depressing the small

rectangular button at the bottom of the cover, and sliding the cover down off the bottom of

the device. Install the batteries in the directions indicated by the battery icons inside the

battery compartment. Replace the battery cover by sliding it back up from the bottom of

the device until the rectangular locking button snaps back into position.

WARNING: USE ONLY ALKALINE BATTERIES. USE OF NON ALKALINE

BATTERIES MAY AFFECT THE ACCURACY OF THE BATTERY LEVEL METER.

WARNING: USE OF BATTERIES WITH A CELL VOLTAGE OF MORE THAN 1.5V

COULD CAUSE DAMAGE TO THE RAD-57.

Battery charge level is indicated by four LED indicators at the bottom of the front panel.

All four indicators will be lit when the batteries are full, with fewer indicators being lit as the

batteries lose their charge. When less than ten (10) percent battery life remains, the final

battery indicator will begin to flash and an audible alarm will sound.

setup

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Commenti su questo manuale

Nessun commento

Masimo Radical Signal Extraction Manuale dell'Operatore Pagina 11

Commenti su questo manuale

Prodotti e manuali riguardandi Misurazione, test & controllo Masimo Radical Signal Extraction